Make your phone compatible
Fork the project and add your phone. When it works, send it back for review and it is merged in for everyone.
Station roster
Runs on these phones
SignalDeck needs a phone with a built-in two-way radio module. What works depends on that module, so the status and notes below are per phone.
| Phone | Status | Radio and notes |
|---|---|---|
| Ulefone Armor 26 UltraWalkie-Talkie version | Fully supported | DMR and FM · VHF 136–174 MHz and UHF 400–480 MHz. Everything in SignalDeck is developed and bench-tested on this phone. |
| ANYSECU W6+ | Supported, beta | FM · UHF only. Has its own device profile. Its radio module gives no signal-strength reading, so the S-meter, band scope, fox hunt and CTCSS detection are not available. |
| Ulefone Armor 20WT | Expected to work | Same module family as the Armor 26 Ultra. The profile is written but untested, so SignalDeck does not take over the radio or transmit on its own yet. Owners: please send a Device report. |
| Blackview Xplore 1 | In progress | Same command protocol, audio over a second serial port. Work in progress and unverified. Owners: please send a Device report. |
| Unihertz Atom XL | In progress | Same command set, inside a USB bridge. Bring-up is under way. |
| Ulefone Armor 3WT | Investigated | An older command set. Looked at, but not supported yet. |
Features vary by phone, depending on its radio module. Another phone? Run the Device report in the app and send it. That is how new phones get added. Device support guide
New phones
Get your phone added
Device report2 steps
Install SignalDeck. On a phone without a profile it starts in discovery mode.
Open Device → Device report → Run all checks and send the zip it makes.
That is how new phones get added. Device support guide
Radio range
The radio modules in these phones cover 136–174 and 400–480 MHz.
There is no airband, HF or 220 MHz reception, and the ANYSECU W6+ is UHF only.